Product Name:
THINVERT® RTU Deposition Aid

Chemical Name:
Not applicable: blend

Chemical Family:
Synthetic isoparaffinic hydrocarbon mixed with emulsifier, nonionic surfactant and water to form a thin invert emulsion.

1. INGREDIENTS: (%w/w, unless otherwise noted)

Isoparaffinic Hydrocarbon Blend Other ingredients, including: Water, Proprietary Emulsifiers and Surfactants

31.6% 68.4%

2. PHYSICAL DATA:

BOILING POINT: No Data

HEALTH INFORMATION AND PROTECTION:

GENERAL:
No toxicity information is available on this specific preparation; this health hazard assessment is based on information that is available on its components.

EYE CONTACT:
Slightly irritating, but does not injure eye tissue.

SKIN CONTACT:
Frequent or prolonged contact may irritate and cause dermatitis. Low order of toxicity.

INHALATION:
High vapor/aerosol concentrations (greater than 700 ppm, attainable at elevated temperatures well above ambient) are irritating to the eyes and respiratory tract, and may cause headaches, dizziness, anesthesia, drowsiness, nausea, and mucous membrane irritation of eyes, nose throat and respiratory passages.

INGESTION:
Small amounts of this product aspirated into the respiratory system during ingestion or vomiting may cause mild to severe pulmonary injury. Minimal toxicity.

3. FIRST AID

EYE CONTACT:
Flush with large amounts of water until irritation subsides. If irritation persists, get medical attention.

SKIN CONTACT:
Remove contaminated clothing and footwear. Was skin with large amounts of soap and water. Wash contaminated clothing and decontaminate footwear before reuse.

INHALATION:
Remove victim to fresh air. If cough or other respiratory problems develop, get medical attention.

INGESTION:
If swallowed, do not induce vomiting. Keep at rest. Get prompt medical attention.

4. FIRE AND EXPLOSION HAZARD:

FLASH POINT: 200 degrees F, 93.4 degrees C.

AUTOIGNITION TEMPERATURE: No Data

GENERAL HAZARD:
Some components of this product are combustible and may form combustible mixtures at or above the flashpoint.

FIRE FIGHTING:
Use water spray to cool fire-exposed surfaces and protect personnel. Isolate fuel supply from fire.

Use foam, dry chemical, or water spray to extinguish fire.

HAZARDOUS COMBUSTION PRODUCTS: No Unusual

5. REGULATORY INFORMATION:

TSCA: All ingredients are on the TSCA Inventory

6. REACTIVITY DATA:

STABILITY: Stable

HAZARDOUS POLYMERIZATION: Will not occur

MATERIALS AND CONDITIONS TO AVOID INCOMPATIBILITY: Strong oxidizing agents

HAZARDOUS DECOMPOSITION PRODUCTS: None

7. STORAGE AND HANDLING:

ELECTROSTATIC ACCUMULATION HAZARD: No special storage requirements for RTU formulation.

STORAGE TEMPERATURE: Ambient

LOADING / UNLOADING TEMPERATURE: Ambient

STORAGE / TRANSPORT PRESSURE: Atmospheric

8. SPILL OR LEAK PROCEDURES:

Wear skin , eye and respiratory protection during cleanup. Soak up liquid with absorbent and shovel into waste container. Cover container and remove from work area. Wash residue from spill area with hot water containing a detergent and flush to a sewer serviced by a wastewater treatment facility.

DISPOSAL METHOD: Discarded product is not a hazardous waste under RCRA, 40 CFR 261.

CONTAINER DISPOSAL: Do reuse empty container except for storage and shipment of original product. Triple rinse, puncture and dispose of empty containers in an approved landfill or return to manufacturer for recycling if service is available.

The preceding information is given in good faith, but no warrenty, express or implied, is made. Reviewed 01/13/93. Revised 09/02/98.